188500
Disponibilidade: Em Estoque
Aviso: Últimas unidades!
Data de disponibilidade:
FEATURES |
Chassis: Countersunk aluminum, orange in color, aluminum side rail
skirts
Roll Cage: Tubular aluminum, orange in color
Drive: Four wheel shaft
Differentials: Front center and rear, bevel gear type
Engine: JL .32 cu in (4.5cc) with slide valve carb, two-stage air
filter, pull starter, 2.9HP @ 39,000RPM
Tuned Pipe: Polished aluminum
Clutch Bell: 14T steel
Radio: 3-ch Ofna HT-2.4EF FHSS, with dual rate steering, and
Savox metal gear steering servo
Radio Tray: Composite one-piece with battery and receiver box
Suspension: C-hub for high clearance to prevent chassis scrub, front
and rear sway bars
Shocks: Oil-filled 17mm Big Bore, hard coated black anodized bodies,
4mm shafts
Shock Towers: Aluminum, 0.16" (4mm)
Tires: Rectangular pattern with foam inserts, outer diameter 5.3"
(136mm), width, 2.5" (63.5mm)
Wheels: Dish type black in color, diameter 3.8" (96mm), width 2.2"
(57mm), 17mm hexes
Rear Wing: High-impact nylon wing black in color
Ball Bearings: Full set, rubber sealed
Fuel Tank: 5oz (150cc) with fuel filter
Caster: Adjustable, caster/toe-in refers to the angle
of the front suspension when viewed from the side of the car in
relation to the chassis
Camber: Adjustable front & rear, camber refers to the angle of the
tops of the tires from vertical when viewed from front
or behind vehicle
INCLUDES |
RTR Hyper SS Cage Off-Road Buggy with Engine, Radio, Air Filter,
Fuel Filter, Glow Plug, Rear Wing and Instruction Manual
REQUIREMENTS |
AA Batteries: Twelve, eight for transmitter, four for radio box
Glow Fuel: Car blend with 15-30% nitro content (20% for break-in)
Glow Igniter, Fuel Bottle, Maintenance and Track Equip.
SPECIFICATIONS |
Length: 18.1" (460mm)
Width: 16.5" (419mm)
Height: 7" (178mm)
Wheelbase: 14" (356mm)
Front and Rear Track: 16.5" (419mm) outer edges of wheels side-to-
side
Carburetor Settings-
Needle Valve: 3 - 3-1/2 turns from closed, adjust for maximum RPM and
power without being too lean or too hot
Low Speed Needle: Set needle to flush, turn clockwise to lean, or
counterclockwise to richen. Do not adjust until needle valve is set
for power and top speed
Barrel Stop Screw: Adjusts idle. Set for 1/16: gap to start new
engine, open more for faster idle