Disponibilidade: Este produto está esgotado
Aviso: Últimas unidades!
Data de disponibilidade:
Volantex RC ASW28 V2 2.6m Plastic Unibody Scale Glider (759-1) PNP
This V2 ASW-28 is a hybrid foam and plastic model with a few nice upgrades over the V1. The wings and tail are EPO foam while the fuselage is blow molded plastic which should give it a good blend of durability and performance. It comes in plug and fly so it doesn't take long to get it ready for flight. All the servos are installed, and it comes with a 4023 brushless motor and folding prop with a 30A ESC. You'll need to provide your own radio system and a 3S 1500mAH lipo battery to finish it off (electronics accesories included only RTF version).
The battery can be accessed after removing the canopy that is secured with snap locks. The wings now have two spars to provide extra rigidity during loops and high bank turns. The wings are easier to install as well with a plastic latch to secure them in place. The room inside the fuse has been increased over the V1 so you can add FPV gear if that's your thing. They also added a wheel under the fuse for rolling landings.
|Technical specification based on the different versions:||KIT||PNP||RTF|
|Wingspan:||2600mm (102.5 in)|
|Overall Length:||1132mm (44.6 in)|
|Flying Weight(without battery):||1050g|
|Prop Size:||1060 Folding Propeller|
|Motor Size:||4023 powerful out runner brushless motor|
|Speed Control:||Easy-Plug 30A Switch-mode BEC brushless ESC|
|Servo||9-gram Servo * 6pcs|
|Recommended Battery:||11.1V 1500mAh ~ 2200mAh Li-Po|
|Charger:||3S LiPo balancing charger, 0.5A|
|Minimum Age Recommendation:||14 years|
|Experience Level:||Beginer ~ Expert|
|Assembly Time:||Less than half hour|
|Is Assembly Required:||Yes|