MOTOR TT RL-1.00H HELI ENGINE 9611

This is the Red Line RL-1.00 Ringed Heli Engine from Thunder Tiger.

FEATURES:

XC2 (Extreme Composite Coating) cylinder liner etched with special criss cross pattern Designed for stable hovering and thrilling 3D manuevers in .50 - .90 size helicopters Precision balanced crankshaft is nickel plated to reduce corrosion Lightened hypereutetic machined Al-Si ringed piston Knife edge, high strength connecting rod Two needle valve carburetor with both hex and FT driver head at same side for easy adjustment, push/pull throttle lever pre-installed Machined aluminum oversized heat sink head Three year limited warranty beginning at date of purchase

INCLUDES:

Red Line RL-1.00 Ringed Heli Engine, Carburetor with Thermo Insulator Gasket, R3 Glow Plug, 2.5 & 3mm Hex Wrenches, Box Wrench and Instructions

REQUIRES:

Fuel: Heli blend, 10-30% nitro and 20% lubricant content Glow Starter, Glow Plug Wrench, Fuel Tubing and Field Equipment

SPECS:

Displacement: 1.00 cu in (16.38cc)

Bore: 1.14" (29.0mm)

Stroke: 0.98" (24.8mm)

Practical RPM: 2,000 - 16,000

Output: 14,500 RPM/3.91BHP

Weight: 22.0oz (625g)

Carburetor Settings, note carb is preset at factory and normally does not require large readjustments

Needle Valve: 3 turns open from fully closed position

Mixture Metering Screw: 1/2 - 1/8 turn counter clockwise to richen mixture or 1/2 - 1/8 turn clockwise to lean mixture

Distance/Mounting Hole Centers Same Side: 0.96" (24.5mm)

Distance/Mounting Hole Centers Opposite Side: 2.04" (52mm)

Width Below Mounting Tabs: 1.76" (44.8mm)

Width at Mounting Tabs: 2.44" (62mm)

Height Mounting Tab/top of Cylinder Head: 3.43" (87.2mm)

Height Crankcase Bottom/top of Cylinder Head: 4.31" (109.5mm)

Center of Crankcase to Front Bearing: 2.19" (55.5mm)

Backplate to Front Bearing: 3.46" (88.3mm)

Cylinder Head Width: 2.05" (52mm)

Crankshaft Size: 5/16-24 UNF