CARRO OFNA HYPER SS PLUS 1/8 14358

FEATURES

• Chassis: Countersunk aluminum, orange in color, aluminum side rail skirts
• Roll Cage: Tubular aluminum, orange in color
• Drive: Four wheel shaft
• Differentials: Front center and rear, bevel gear type
• Engine: JL .32 cu in (4.5cc) with slide valve carb, two-stage air filter, pull starter, 2.9HP @ 39,000RPM
• Tuned Pipe: Polished aluminum
• Clutch Bell: 14T steel
• Radio: 3-ch Ofna HT-2.4EF FHSS, with dual rate steering, and Savox metal gear steering servo
• Radio Tray: Composite one-piece with battery and receiver box
• Suspension: C-hub for high clearance to prevent chassis scrub, front and rear sway bars
• Shocks: Oil-filled 17mm Big Bore, hard coated black anodized bodies, 4mm shafts
• Shock Towers: Aluminum, 0.16" (4mm)
• Tires: Rectangular pattern with foam inserts, outer diameter 5.3" (136mm), width, 2.5" (63.5mm)
• Wheels: Dish type black in color, diameter 3.8" (96mm), width 2.2" (57mm), 17mm hexes
• Rear Wing: High-impact nylon wing black in color
• Ball Bearings: Full set, rubber sealed
• Fuel Tank: 5oz (150cc) with fuel filter
• Caster: Adjustable, caster/toe-in refers to the angle of the front suspension when viewed from the side of the car in relation to the chassis
• Camber: Adjustable front & rear, camber refers to the angle of the tops of the tires from vertical when viewed from front or behind vehicle

INCLUDES

RTR Hyper SS Cage Off-Road Buggy with Engine, Radio, Air Filter, Fuel Filter, Glow Plug, Rear Wing and Instruction Manual

REQUIREMENTS

• AA Batteries: Twelve, eight for transmitter, four for radio box
• Glow Fuel: Car blend with 15-30% nitro content (20% for break-in) Glow Igniter, Fuel Bottle, Maintenance and Track Equip.

SPECIFICATIONS

• Length: 18.1" (460mm)
• Width: 16.5" (419mm)
• Height: 7" (178mm)
• Wheelbase: 14" (356mm)
• Front and Rear Track: 16.5" (419mm) outer edges of wheels side-to- side

Carburetor Settings-

• Needle Valve: 3 - 3-1/2 turns from closed, adjust for maximum RPM and power without being too lean or too hot
• Low Speed Needle: Set needle to flush, turn clockwise to lean, or counterclockwise to richen. Do not adjust until needle valve is set for power and top speed
• Barrel Stop Screw: Adjusts idle. Set for 1/16: gap to start new engine, open more for faster idle