CARRO OFNA TRUGGY MUTILATOR 28 RTR 34313

This is the radio controlled, glow powered, 1/8 scale ready to run Ofna Mutilator Power Start Truggy.

FEATURES:

• Chassis: 0.12" (3mm) thick aluminum hard anodized
• Engine Starter: Electric shaft type
• Engine: Ofna .28 cu in (4.6cc) slide valve carburetor, heavy duty foam air filter and glow plug
• Exhaust: Polished aluminum dual chambered tuned pipe and header
• Radio: Ofna 2-channel AM transmitter and reciever with SX-002 high torque servo and SX-001 standard servo
• Radio Box: Low profile nylon fully enclosed box
• Ball Bearings: Full set
• Shocks: Four aluminum threaded Big Bore oil filled shocks w/blue springs 0.16" (4mm) thick aluminum shock towers
• Fuel Tank: 4.9oz (145cc) flip top siphon type Ttnk
• Clutch: 3-shoe, constructed of nylon
• Transmission: Single speed
• Main Gear: 62T steel spur gear
• Differentials: Three, sealed with anodized aluminum center diff plate
• Brake: Two fiberglass brake disks
• Tires: LPR Bow-Tie
• Width: 67.25mm (2.6")
• Diameter: 148mm (5.8")
• Hex: 17mm
• Wheels: LPR White dish type w/17mm hex adapters
• Body: Pre-painted truggy body with heavy duty nylon racing wing
• Caster: Front and rear adjustable, caster/toe-in refers to the angle of the front suspension when viewed from the side of the car in relation to the chassis
• Camber: Front and rear adjustable, camber refers to the angle of the tops of the tires from vertical when viewed from front or behind vehicle
• Suspension: C-Hub

INCLUDES:

Ofna Mutilator Power Start Truggy, .28 size engine w/electric power starter, pre-installed radio system w/high torque steering servo, pre-painted body, pre-mounted tires on white dish wheels, aluminum threaded shocks, instruction manual and decals, glow starter and fuel bottle

REQUIRES:

• Radio Batteries: 12 AA size, 8 for transmitter and four for receiver D size battery for the included glow starter
• Fuel: 2-cycle glow fuel with 10%-15% nitromethane, 16% lubricant

SPECS:

Chassis-

• Length: 21.5" (546mm)
• Width: 15.25" (413mm)
• Height: 7" (178mm)
• Weight: 9.25lbs (4195g)
• Wheelbase: 14.5" (368mm)
• Track: 13.5" (343mm)

Body-

• Length: 19.5" (495mm)
• Width: 7.5" (190mm)
• Height: 5.5" (140mm)

COMMENTS:

For Replacement Ball Bearings use:
Qty. Size Location Qty. Bearing Set

6 8x16mm Front, Rear & Center Diffs 3 DTXC1585
4 8x16mm Front and Rear gear boxes 3 DTXC1585
4 8x16mm Front Knuckles 2 DTXC1585
4 8x16mm Rear Hubs 2 DTXC1585
2 5x10mm Clutch Bell 1 DTXC1535

Carburetor Needle Settings;
Master Needle Valve, 3-3-1/2 turns from closed
Low Speed Needle, Flush with ball end
Barrel Stop Screws (used to adjust idle) 1/16" gap

It is not possible to request a specific radio channel when ordering because they are supplied by the manufacturer at random.